CO Combustible Gas Sensor Module – MQ9

-7%

CO Combustible Gas Sensor Module – MQ9

This sensor module is made using MQ9, a low cost semiconductor sensor which can detect the presence of carbon monoxide gas at concentrations from 10 to 1000 ppm and combustible gases at concentrations from 100 to 10,000 ppm. The sensitive material used for this sensor is SnO2, whose conductivity is lower in clean air. It’s conductivity increases as the concentration of sensing gases increases. MQ9 CO Combustible gas sensor module can be easily interfaced with Microcontrollers, Arduino Boards, Raspberry Pi etc using an Analog to Digital Converter (ADC).

470.00 439.00

Out of stock

  • Description
  • Additional information
  • Reviews (0)

Description

This sensor module is made using MQ9, a low cost semiconductor sensor which can detect the presence of carbon monoxide gas at concentrations from 10 to 1000 ppm and combustible gases at concentrations from 100 to 10,000 ppm. The sensitive material used for this sensor is SnO2, whose conductivity is lower in clean air. It’s conductivity increases as the concentration of sensing gases increases. This module provides both digital and analog outputs. MQ9 CO Combustible gas sensor module can be easily interfaced with Microcontrollers, Arduino Boards, Raspberry Pi etc using an Analog to Digital Converter (ADC).

Features

  • Good sensitivity to CO / Combustible Gas
  • High sensitivity to Methane, Propane and CO
  • Long life
  • Low cost
  • On-board LED indicator
  • Both digital and analog outputs

Technical Data

  • Operating Voltage : 5V ±0.1
  • Operating Temperature : -10°C ~ 50°C
  • CO Detection Range : 10 ~ 1000 ppm
  • Combustible Gas Detection Range : 100 ~ 10,000 ppm

Pin Out

  • VCC – Input Power Supply
  • GND – Supply Ground
  • DO – Digital Output
  • AO – Analog Output

Datasheet

Additional information

Weight 7 g
Dimensions 32 x 22 x 20 mm