Intelligent ambulance with automatic traffic control

Home Forums Project Discussions Intelligent ambulance with automatic traffic control

This topic contains 2 replies, has 3 voices, and was last updated by  Ligo George 6 months, 2 weeks ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #12653

    vidya
    Participant

    Following is the link that is related to this project-http://www.engineersgarage.com/contribution/intelligent-ambulance-automatic-traffic-control

    I have a problem regarding the remote which has to be connected in the ambulance unit which tells about the lane the ambulance is travelling.Please do help where does the remote has to be  connected to the PIC microcontroller or it can be done by connecting it to HT12E?

    #12662

    ebenmoore
    Participant

    both options are the best. if you are connecting the remote directly to pic, then plug through the Tx and Rx of the PIC.

    And if you are using the Encoder(HT12E), Connect the Data Pin of the encoder to the PIC and make sure that at the PIC, the data lines are Inputs to the PIC. so, you then configure your channels.

     

    #12671

    Ligo George
    Keymaster

    If you are directly connecting it to UART of the microcontroller, it is better to keep low baudrate.

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.