Question about the Voltmeter and Ammeter

Home › Forums › Project Discussions › Question about the Voltmeter and Ammeter

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • October 1, 2014 at 12:08 pm #8881
    Sly
    Participant

    Hi
    I’ve an interest for the Voltmeter and Ammeter using Pic microcontroller posted on your site.
    However, I miss some information before ordering parts:
    What is the crystal speed?
    Is all resistors are 1 watt or more?
    And I suppose that the tolerance should be as less as possible, isn’t it?

    Thanks for your answer
    SLy

    October 3, 2014 at 1:27 pm #9419
    Ligo George
    Keymaster

    Hello, I used 8MHz crystal in that project.. You may use 4MHz or 20MHz. Just need to edit it in MikroC project settings.
    Use 1/4 watt resistors… .. and select 0.47 ohm fusible resistor as per your current requirements.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.
>