PIC Microcontroller MPLAB XC8 Tutorials

PIC Microcontroller Tutorials using MPLAB XC8 Compilers and MPLAB X IDE. Intended for beginners, electronics hobbyists, students, professionals and educational purposes.

Generating PWM with PIC Microcontroller – MPLAB XC8

Pulse Width Modulation (PWM) is the one of the simple and most commonly used technique to produce analog voltages from digital signals. It has a wide variety of applications such as Digital to Analog Converter (DAC), DC Motor Speed Control, Sine Wave Inverters, Brightness control etc. PWM signals are ON - OFF signals (HIGH or LOW) (hence the name Pulse) whose HIGH or ON duration is changed (hence Width Modulation) in accordance with our requirements. The fraction of time period for...

May 21, 2015By Ligo GeorgeMPLAB XC8, PIC Microcontroller, Tutorials16F877A, CCP, Microcontroller, MPLAB, MPLAB IDE, MPLAB XC8, PIC, PWM, XC832 CommentsRead more...

Using ADC of PIC Microcontroller – MPLAB XC8

In this tutorial we will learn, how to use the ADC module of a PIC Microcontroller using MPLAB XC8 compiler. For demonstration we will use the commonly available PIC 16F877A microcontroller. Every physical quantity found in nature like temperature, humidity, pressure, force is analog. We need to convert these analog quantities to digital to process it using a digital computer or a microcontroller. This is done by using Analog to Digital Converters. An Analog to Digital Converter or ADC is a device...

November 12, 2015By Ligo GeorgeMPLAB XC8, PIC Microcontroller, Tutorials16F877A, Microcontroller, MPLAB, MPLAB XC8, PIC, Proteus, Tutorials, XC828 CommentsRead more...

I²C Communication with PIC Microcontroller – MPLAB XC8

I2C or IIC or I2C stands for Inter-Integrated Circuit. It is a very popular multi-master, multi-slave serial communication interface developed by Philips. I2C uses two bidirectional open drain data lines, Serial Data (SDA) and Serial Clock (SCL) with pull up resistors as shown below. Unlike UART, you can connect and communicate to multiple devices using the same I2C bus. I2C Communication I2C is a master slave protocol. It means that devices connected to I2C bus will be either master or slave. The...

April 11, 2016By Ligo GeorgeMPLAB XC8, PIC Microcontroller, Tutorials16F877A, I²C, MPLAB, MPLAB IDE, MPLAB X IDE, PIC, XC869 CommentsRead more...

SPI Communication with PIC Microcontroller – MPLAB XC8

SPI (Serial Peripheral Interface) is a full duplex synchronous serial communication interface used for short distance communications. It is usually used for communication between different modules in a same device or PCB. SPI devices communicates each other using a master slave architecture with a single master. SPI Communication SPI is called as a 4-wire bus as it requires four wires for its communication as shown above. In the case of single slave communications we need only 3 wires, as slave select (SS)...

May 1, 2017By Ligo GeorgeMPLAB XC8, PIC Microcontroller, Tutorials16F877A, MPLAB, PIC, SPI, XC82 CommentsRead more...